An Interesting Callout Near Morpeth
An interesting callout this morning to a returning commercial customer near Morpeth.
The report came in that one of two side-by-side hot tubs had mysteriously stopped heating while guests were staying at the property. The issue had been reported by the guests.
Investigating the Heating Problem
Upon investigation, the hot tub was working fine electrically, with current recorded by an amp meter on the heater.
The circulation pump was also running fine, although it was slightly noisier than expected for a relatively new pump that I had installed earlier this year.
I noticed that the behaviour of the bubbles coming from the circulation pump's heat return fitting was abnormal, suggesting a potential blockage or another reason why water was not flowing sufficiently.
I removed further side panels to trace the pipework and check that no valves had been accidentally closed.
During this inspection, I discovered that the suction line running from the filter housing to the circulation pump had collapsed and was showing signs of significant pressure damage.
The Damage and Required Repairs
The pipework, fittings and filter housing will need to be removed and replaced to enable the hot tub to return to operation.
Further monitoring will also be required to establish whether the circulation pump has suffered pressure damage or whether any other connected pipework has sustained heat transfer or pressure damage.
Collapsed hot tub circulation pipe discovered during a heating fault investigation near Morpeth, Northumberland.
Close up of hot tub circulation pipe
What Caused the Problem?
The likely cause was an excessive number of bathers using the hot tub at the same time.
With too many people in the tub, a significant amount of water may have spilled over the sides. Once the bathers exited, this would have left the water level considerably lower than normal.
The water level appears to have fallen below the filter housing, allowing air to be drawn into the suction pipework instead of a consistent flow of water. This can lead to circulation problems and pump cavitation, potentially contributing to damage to the pump and associated pipework.
In this case, the collapsed suction pipe and damaged fittings meant that further repairs were necessary before the hot tub could be returned to normal operation.
Why Proper Hot Tub Fault Diagnosis Matters
When a hot tub stops heating, it's natural to assume that the heater itself has failed. However, as this particular callout demonstrates, the problem isn't always as straightforward as it first appears.
Although the heater was operating electrically, the circulation system wasn't functioning as it should. Simply replacing the heater would not have addressed the underlying problem.
Hot tubs rely on several interconnected components working together, and a fault in one area can affect the performance of another. That's why identifying the actual cause of a problem is so important before recommending repairs or replacement parts.
At Northumbria Hot Tubs, we believe in investigating the cause of a fault, not simply replacing the component that appears to be responsible.
Whether your hot tub isn't heating, is displaying an error code or has developed a circulation problem, our experienced technicians can help identify the issue and recommend the appropriate next steps.
Find out more about our professional hot tub repairs across Northumberland, or contact us to discuss a problem with your hot tub or swim spa.
